HP DesignJet 1000 Series Take-Up Reel User's Guide - C6079-90001

21 HP DesignJet 1000 Series Take-Up Reel
Loading Paper on to the Take-Up Reel
Before using the take-up reel, ensure that it has been properly installed (see
preceding pages). In particular, the core tube should be mounted on the spindle.
CAUTION HP Bright White Inkjet Paper is available in 150-ft and 300-ft rolls. The take-
up reel can only completely roll up 150-ft rolls.
CAUTION Backlit paper with a separate slip sheet is not recommended for use with the
take-up reel.
■ If you already have a roll of paper in the printer, go to the front panel and select
the Roll Paper menu. Set the “TUR loaded” option to Yes. Now go to step 1
below.
■ If you do not already have a roll of paper in the printer, load the roll according to
the instructions in Chapter 3 of the User’s Guide. Soon after you have selected
the paper type, the front panel will offer the option “Load Take-Up Reel (TUR)”,
which can be set to No or Yes. Select Ye s . Continue with step 1 below.
1 The front panel will prompt you to move the paper using the arrow keys. Use the ↓
key to move the leading edge of the paper down until it is level with the centre of
the core tube. Make sure the paper passes in front of the deflector, as shown below.
If you move the paper too far by mistake, use the ↑ key to move the paper back up.
Turset.book Page 21 Monday, April 19, 1999 6:12 PM