HP StorageWorks DAT SAS Tape Drives User Guide (DW092-90918, June 2010)
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
6 Operating your tape drive
In this chapter:
• “Front panel, DAT 320 tape drives” on page 43
• “Front panel, DAT 160 tape drives” on page 44
• “LED sequences, DAT 320 and DAT 160 tape drives” on page 44
• “Loading and unloading” on page 47
• “Removing power from the drive” on page 48
Front panel, DAT 320 tape drives
5. drive LED1. cartridge slot
6. encrypt LED2. power button and LED (external drives only)
7. ready LED3. clean LED
8. eject button4. tape LED
Figure 23 Front panel, HP StorageWorks DAT 320 external drive
.
DAT SAS Tape Drives 43