HP StorageWorks DAT SAS Tape Drives User Guide (DW092-90918, June 2010)
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
5. Connect the replacement HP mini-SAS or Infiniband cable to the host SAS controller, as shown
below.
Figure 14 Cable routing with replacement HP mini-SAS or Infiniband cable
.
4. SAS connector to tape drive1. Replacement cable
5. Power connector to server's power supply2. Connect replacement split SAS cable to host HBA
3. Connect replacement split SAS cable to disk bay (remove tie wrap and dust cover on supplied cable)
Installing an internal DAT tape drive34