HP D6000 Disk Enclosure Maintenance and Service Guide
Removal and replacement procedures 24
2.
Remove the hard drive.
To replace the component:
1. Fully extend the hard drive lever.
2. Push the hard drive all the way into the drive bay, and then close the lever.
Fan
IMPORTANT: Configurations using power cord part number 142263-004, located on the
power cord label, require that the power cord be removed before removing a fan.
Before removing a fan, do the following:
• Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page 46).
• Be sure that your configuration can support your actions. If the proper redundancy is not in place,
power down the D6000 before beginning this procedure.
To remove the component:
1. Be sure that the hard drive drawer is closed.