HP StorageWorks D2D Backup System User Guide (EH880-90950, October 2007)

NOTE:
If several disks fail, the RAID state will still display a fault, but you are given the option
of initializing the RAID array. This will make the HP D2D Backup System usable again,
but you will have lost your data.
Replacing a complete unit
If you a re sent an empty unit as a replacement, you must transfer the disks from the old unit into the new
unit. Follow the steps outlined in the previous section to move each disk into the new unit. Further advice
is available on the Suppor t website, w
ww.hp.com/support.
122
Hard disk replacement