HP Color LaserJet Enterprise CP4020/CP4520 Series Printer - Software Installation Guide

i. ON

j. ADDRESS

3. Press the up arrow

or the down arrow to select the first character of the address. Press the

OK button.

Repeat this process for each character in the address.

NOTE: You must press the OK button after entering each character.

4. Press the up arrow or the down arrow to select the stop character . Press the OK button.

5. Press the Home button

to return to the Ready state.

Manually configure IPv4 TCP/IP parameters from the control panel

1. Press the Home button

2. Open each of the following menus. Press the down arrow to highlight it and then press the

OK button to select it.

a. CONFIGURE DEVICE

b. I/O

c. EMBEDDED JETDIRECT MENU

d. TCP/IP

e. IPV4 SETTINGS

f. CONFIG METHOD

g. MANUAL

h. MANUAL SETTINGS

i. <IP ADDRESS>, SUBNET MASK, or DEFAULT GATEWAY

3. Press the up arrow

or the down arrow to increase or decrease the number for the first byte

of the IP address, subnet mask, or default gateway.

4. Press the OK button to move to the next set of numbers, or press the back arrow

to move to

the previous set of numbers.

5. Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and

then press the OK button to save the setting.

6. Press the Home button

to return to the Ready state.

ENWW Network installation 3

English