HP Commercial LaserJet Printers and MFPs - Imaging and Printing Security Best Practices

Chapter 3 HP LaserJet and Color LaserJet MFP Security Checklist 13
4. Click the Config tab in the lower half of the Device List view to show settings
available for configuration (Figure 3).
Figure 3: The Config tab displays settings available for configuration.
The Config tab contains all of the settings recommended in this checklist.
Tip:
If you are having a problem configuring a setting, try configuring it
using the individual device’s configuration page. You can also attempt
to configure the setting using the EWS of the MFP.
Sometimes Web Jetadmin can lose track of MFP credentials. If this
happens, some settings might fail. Clear the Web Jetadmin Device
Cache (see Web Jetadmin Help) and re-enter the MFP credentials.
The next step is to ensure that any installed HP Secure Hard Disks are configured:
Configuring HP Secure Hard Disk
If you have an HP Secure Hard Disk installed you need to verify data encryption is enabled (this
should happen by default after initial hard drive installation).
WARNING: If your HP Secure Hard Disk is not already
configured to encrypt your data, consult your documentation to resolve
this issue. Failing to configure your HP Secure Hard Disk before starting
this checklist will reset all security settings to factory defaults and require
you to repeat this checklist again when you configure the drive.