HP Color LaserJet CP3525 Series Printers - User Guide

Control panel message Description Recommended action
unless the print quality is no longer
acceptable. After an HP supply has reached
its approximated end of life, HP’s premium
Protection Warranty on that supply ends. You
can configure the product to continue printing
by using the REPLACE SUPPLIES menu.
For more information about the REPLACE
SUPPLIES menu, see
System setup menu
on page 27.
SUPPLIES menu, see System setup menu
on page 27.
REPLACE SUPPLIES
To continue press OK
Pages remaining for at least two supplies
have reached the low threshold. The product
was set to stop printing when a supply needs
to be ordered.
Press the OK button to continue printing until
the supply reaches its estimated end of life.
Or, configure the product to continue printing
by using the REPLACE SUPPLIES menu.
For more information about the REPLACE
SUPPLIES menu, see
System setup menu
on page 27.
REPLACE SUPPLIES - OVERRIDE IN USE The product indicates when a supply level is
at its estimated end of life. The actual life
remaining might be different than the
estimation. Have a replacement supply
available to install when print quality is no
longer acceptable. The supply does not need
to be replaced now unless the print quality is
no longer acceptable. Once an HP supply has
reached its estimated end of life, HP’s
premium Protection Warranty on that supply
has ended. Printing can continue using
override (see REPLACE SUPPLIES menu
item).
NOTE: Printing while in Override mode
eventually results in unsatisfactory print
quality.
Open the SUPPLIES STATUS menu for
information about each supply. Press the
OK button for detailed information.
REPLACE SUPPLIES - Using black only You can configure the product to print using
only black when the level of a color supply
has reached its estimated end of life.
However, the color supply might still be able
to produce acceptable print quality. To print
in color, either replace the color supply or
reconfigure the printer by using the
REPLACE SUPPLIES menu on the control
panel. For more information about the
REPLACE SUPPLIES menu, see
System
setup menu on page 27.
The supply life remaining is used to
determine if a supply is very low. The supply
life remaining is an approximation only and
varies depending on the types of documents
printed and other factors.
No user input is required for printing to
continue in black. To continue printing in
color, either replace the supply or reconfigure
the printer by using the REPLACE
SUPPLIES menu on the control panel. For
more information about ordering supplies,
see
Supplies and accessories on page 219.
For more information about the REPLACE
SUPPLIES menu, see
System setup menu
on page 27.
REPLACE TONER COLLECTION UNIT The toner collection unit has reached its
estimated capacity.
Replace the toner collection unit or, if you
wish to have the toner collection unit operate
past its estimated capacity, reconfigure the
printer to use OVERRIDE AT OUT 2 in the
REPLACE SUPPLIES menu. For more
information about the REPLACE
SUPPLIES menu, see
System setup menu
on page 27.
Table 11-1 Control-panel messages (continued)
ENWW Control-panel messages 181