HP PCL/PJL reference - Printer Job Language Technical Reference Manual

EN Environment Commands 6-17
INTRAY5SIZE Returns the size of the paper currently
installed in the first optional input tray.
INTRAY5SIZE is a valid variable only if
the optional tray currently is installed. If
it is not installed, the printer returns “?”
instead of a tray size, indicating the
variable is unknown.
LETTER, LEGAL,
A4, A3, LEDGER,
JISB4, JISB5,
EXECUTIVE,
CUSTOM
INTRAY6SIZE
INTRAY7SIZE
INTRAY8SIZE
Returns the paper size currently
installed in these optional input trays.
INTRAYxSIZE is valid only if the
optional tray is installed. If not installed,
the printer returns “?” instead of a tray
size, indicating the variable is unknown.
LETTER, LEGAL,
A4, and others
(tray-dependent)
IOBUFFER Sets the value of the I/O buffering
variable.
ON, OFF, AUTO
IOSIZE Sets up the size, in Kbytes, of the
configurable I/O buffers when
IOBUFFER=ON. The size is set in
increments of 10 Kbytes (up to 100
Kbytes, then in 100 Kbyte increments).
10 to maximum
available memory
JOBATTR Used to append a string to a list of job
attribute strings associated with the
current job.
“Attribute String”
JOBID Used to enable or disable the job ID
information returned in the status
readback at the start and end of the job.
Both the current and default variables
are set when either the SET or
DEFAULT command is used. This
variable can be set to ON or to its
default value of OFF.
OFF, ON
JOBIDVALUE This variable is used to change the
current job ID number. It is used to
facilitate reproducible test results.
Normally job ID numbers are assigned
sequentially by the printer. As a result,
job IDs would vary depending on which
job ran prior to the current job.
0 to 65535
General PJL Environment Variables (continued)
Variable Description
Sample Value
Range