HP Color LaserJet 4700 - User Guide

ManualsBrandsHP ManualsPrinterHP Color LaserJet 4700dtn Printer

141

142

143

144

145

146

147

148

149

150

Macintosh

1. On the File menu, click Print (Command + P).

2. Select the Finishing option.

3. For the Output destination, select Stapler.

4. In the Finishing option, select 1 Staple.

Selecting the stapler at the control panel

1. Press Menu to enter the menus.

2. Press

to highlight CONFIGURE DEVICE, and then press .

3. Press

to highlight STAPLER STACKER, and then press .

4. Press

to highlight STAPLES, and then press .

5. Press

to highlight 1-EDGE, and then press .

NOTE Selecting the stapler at the printer control panel changes the default setting to

STAPLE. It is possible that all print jobs might be stapled. However, settings that are changed

in the printer driver override settings that are changed at the control panel.

NOTE When configuring to STAPLES = 1-EDGE, the OFFSET menu is set to DISABLED. Jobs

cannot be both stapled and offset.

Job offset

When the job offset feature is enabled, the stapler/stacker offsets each print job for easy identification.

Letter, A4, JIS B5, 215.9 x 330 mm (8.5 x 13 in), and legal size paper can be offset.

The job offset option is configured only from the printer control panel. It cannot be activated through the

printer driver. Once this feature is configured, all subsequent print jobs are offset.

NOTE A print job can be either stapled or offset. If job offset is configured at the control panel

but not in the printer driver, the job is offset. If offset is configured at the control panel but the

printer driver is configured to staple the job, the printed document is stapled, and the offset feature

is overridden.

Configuring job offset at the control panel