HP Jetdirect Print Servers - Administrator Guide

ENWW Using the Embedded Web Server 133
Note If you are upgrading from a version prior to X.24.00
series, you must perform the upgrade again if
supported non-English languages are desired.
LPD Queues
The LPD Queues page allows you to specify LPD (line printer
daemon) print queues on the Jetdirect print server. For more
information on LPD printing and print queues, see Chapter 5,
“Configuring for LPD Printing”.
LPD printing must be enabled on the print server before you can
set LPD queues. If LPD is disabled, go to the Misc. Settings
tab to
enable it.
If LPD printing is enabled, ten different named print queues are
available. Four of these queues are configured automatically and
their parameters cannot be changed. The remaining six queues can
be defined by the user.
The six user-defined queues can be set up with character strings --
such as job control commands -- that are automatically added before
or after the print job. You can define up to eight named strings, and
you can set up each queue so that any of these named strings
precedes the print data (“prepend string name”) or follows the print
data (“append string name”).
LPD Queue Parameters for setting up LPD queues are described
below. See Table 4.9
.