HP Commercial LaserJet Printers and MFPs - Imaging and Printing Security Best Practices

Chapter 5 HP LaserJet and Color LaserJet MFP Security Checklist 68
Chapter 5: Settings List
This section is a complete list of the settings recommended in this checklist. This section does not
include instructions or explanations. It is intended to be used as a check-off list of the recommended
settings to help ensure that you complete the entire configuration. See the Network Security section
(above) and the Ramifications section (below) for information on each setting.
NOTE:
This section lists recommended settings for reasonable security on the
most common networks that include MFPs. MFPs configured according
to this list are considered secure, but HP does not warrant or guarantee
that this configuration prevents or limits all malicious network attacks.
Remember that these settings are recommended for the most common
types of network environment. Your environment may require
configurations not recommended in this checklist. Consider each setting
in the context of your network environment needs and constraints.
Recommended Settings
Initial Settings
 Configure Advanced Security Settings (ACL, Firewall, LDAP, Kerberos, etc.)
 Verify your HP Secure Hard Disk is functioning correctly.
 Configure SNMPv3 (Security page).
Device Category Settings
 Configure I/O Timeout to End Print Job
 Configure Job Hold Timeout.
 Enable Job Retention.
Network Category Options
 Configure Enable Features options.
 Enable EWS Config.
 Disable Telnet Config.
 Disable SLP Config.
 Disable FTP Printing.
 Disable LPD Printing.
 Enable 9100 Printing.
 Disable IPP Printing.