HP PCL/PJL reference - Printer Job Language Technical Reference Manual

A-56 Product-Specific Feature Support EN
HP LaserJet 5Si/ 5SiMx/5Si Mopier Comments
HP LaserJet 5Si, 5SiMx, and 5Si Mopier printers have several
features that differentiate them from most of the other LaserJet
printers. The following features should be kept in mind when writing
PJL code for these printers.
• Three standard paper input sources are provided (two
500-sheet paper cassettes and a 100-sheet multi-purpose
tray).
• Input selection can be controlled by selecting a media type
rather than a particular input tray—this feature is controlled
using PCL, instead of PJL, but it may affect the manner in
which PJL code is written (see the PCL 5 Comparison Guide
for more information concerning this feature).
• Jobs may be canceled using the printer control panel. If
unsolicited status is enabled when jobs are canceled, the
printer responds with a status message (see the “Job
Cancellation” section in Chapter 5 for more information).
• A PCL and PostScript-supported disk accessory is available
for storing information such as fonts and macros. Chapter 9
describes the PJL file system that manages the files on the
printer disk.
• The default symbol set is PC-8 instead of Roman-8.
• The LaserJet 5Si and 5SiMx printers have a top (correct-order)
output tray, holding 500 pages, and a side (100-sheet face-up)
output tray.
• The LaserJet 5Si Mopier printer has a top (correct-order)
output tray, holding 500 pages, a side (100-sheet face-up)
output tray, a multi-bin mailbox (5 bins) and a stapler bin. (See
the following page for instructions on stapling or collating
documents.)