HP Jetdirect Print Servers - Administrator Guide

ENWW The HP Jetdirect Control Panel Menu 289
ATALK ENABLE (Ethernet/Fast Ethernet only)
ON: Enable the AppleTalk protocol
OFF: Disable the AppleTalk protocol
DLC/LLC ENABLE ON: Enable the DLC/LLC protocol
OFF: Disable the DLC/LLC protocol
SECURE
WEB
For configuration management, specify
whether the embedded Web server will
accept communications using HTTPS
(Secure HTTP) only, or both HTTP and
HTTPS.
HTTPS REQUIRED: For secure, encrypted
communications, only HTTPS access is
accepted. The print server will appear as a
secure site.
HTTPS OPTIONAL: Access using either
HTTP or HTTPS is permitted.
RESET
SECURITY
Specify whether the current security settings
on the print server will be saved or reset to
factory defaults.
NO (default): The current security settings are
maintained.
YES: Security settings are reset to factory
defaults.
LINK SPEED (10/100Base-TX print servers only) Selects
the network link speed and communication
mode for the 10/100TX print server. For
proper communications, the Jetdirect
settings must match the network.
AUTO: (Default) The print server will
automatically configure itself to match the
network’s link speed and communication
mode. If it fails, 100TX HALF is set.
10T HALF: 10Mbps, half-duplex operation.
10T FULL: 10 Mbps, full-duplex operation.
100TX HALF: 100 Mbps, half-duplex
operation
100TX FULL: 100 Mbps, full-duplex operation
Table C.2 HP Jetdirect Graphical Control Panel Menu (7 of 7)
Menu Item Options Description of settings