HP Jetdirect Print Servers - Administrator Guide

ENWW HP Jetdirect Configuration Page 240
46 INVALID SERVER
ADDRESS
The TFTP server IP address specified for the HP Jetdirect
print server (through BOOTP) is an invalid IP address for
specifying a single node. Check your Bootptab file for proper
entries.
47 INVALID TRAP
DEST ADDRESS
One of the SNMP trap (Trap PDU) destination IP addresses
specified for the HP Jetdirect print server (through TFTP) is
an invalid IP address for specifying a single node. Check
your TFTP configuration file.
48 CF ERR - FILE
INCOMPLETE
The TFTP configuration file contained an incomplete last
line that did not end in a newline character.
49 CF ERR - LINE TOO
LONG
A line being processed in the TFTP configuration file was
longer than the HP Jetdirect print server could accept.
4A CF ERR -
UNKNOWN
KEYWORD
A TFTP configuration file line contained an unknown
keyword.
4B CF ERR - MISSING
PAR AMET ER
A line in the TFTP configuration file was missing a required
parameter.
4C CF ERR - INVALID
PARAMETER
A line in the TFTP configuration file contained an invalid
value for one of the parameters on that line.
4D CF ERR - ACCESS
LIST EXCEEDED
The TFTP configuration file specified too many access list
entries using the “allow:” keyword.
4E CF ERR - TRAP
LIST EXCEEDED
The TFTP configuration file specified too many trap
destination list entries using the “trap-destination:” keyword.
4F TFTP REMOTE
ERROR
The TFTP transfer of the configuration file from the host to
the HP Jetdirect print server failed with the remote host
sending a TFTP ERROR packet to the print server.
50 TFTP LOCAL
ERROR
The TFTP transfer of the configuration file from the host to
the HP Jetdirect print server failed with the local print server
encountering some form of inactivity timeout, or excessive
retransmissions situation.
51 TFTP RETRIES
EXCEEDED
The overall retrying of the TFTP transfer of the configuration
file from the host to the HP Jetdirect print server has
exceeded a retry limit.
52 BAD BOOTP/DHCP
REPLY
An error was detected in the BOOTP or DHCP reply that the
HP Jetdirect print server received. The reply either had
insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP/DHCP server port (67/udp).
Table 9.12 Error Messages (9 of 11)
Error Code and
Message
Description