Broadcom BACS for HP FlexFabric and StoreFabric Adapters User Guide

Installing the management application 24
Enabling HTTP
1. Start the CIM Server if the CIM Server is not already started.
For more information, see "Starting and stopping the CIM Server (on page 23)."
2. (Optional) To set the HTTP port, run the following command:
cimconfig -s httpPort=5988 -p
The property is not available for Inbox OpenPegasus.
3. Enable an HTTP connection:
cimconfig -s enableHttpConnection=true -p
4. Stop and restart the CIM Server:
cimserver –s and cimserver
Enabling HTTPS
1. Start the CIM Server if the CIM Server not already started.
For more information, see "Starting and stopping the CIM Server (on page 23)."
2. (Optional) To set the HTTPS port, run the following command:
cimconfig -s httpsPort=5989 -p
The property is not available for Inbox OpenPegasus.
3. Enable an HTTPS connection:
cimconfig -s enableHttpsConnection=true -p
4. Stop and restart CIM Server:
cimserver -s and cimserver
Installing Broadcom CIM provider
1. Be sure that OpenPegasus is installed properly.
2. Install the Broadcom CIM provider:
% rpm -i BRCM_CMPIProvider-{version}.{arch}.rpm
Uninstalling Broadcom CIM provider
Run % rpm -e BRCM_CMPIProvider.
Configuring the Linux firewall
By default, CimXML over HTTP uses TCP and port number 5988, and CimXML over HTTPS uses TCP and port
number 5989. Use the following instructions to open the ports, or other user-defined ports, on a Linux
firewall.
Red Hat
To open ports in a Red Hat firewall:
1. Select System→Administration→Firewall.
2. Select Other Ports.
3. In the Port and Protocol dialog box, select User Defined.
4. In the Port/Port Range field, add the port number.