Fabric OS Administrator's Guide v7.0.0 (53-1002148-02, June 2011)

Fabric OS Administrator’s Guide 439

53-1002148-02

F_Port trunking

Figure 72 shows a switch in AG mode without F_Port masterless trunking. Figure 73 shows a

switch in AG mode with F_Port masterless trunking.

FIGURE 72 Switch in Access Gateway mode without F_Port trunking

FIGURE 73 Switch in Access Gateway mode with F_Port masterless trunking

NOTE

You do not need to manually map the host to the master port because Access Gateway will perform

a cold failover to the master port.

See “Configuring F_Port trunking for Access Gateway” on page 443 for instructions on configuring

F_Port trunking.

Requirements for F_Port trunking on an Access Gateway

In addition to the requirements listed in “Requirements for trunk groups” on page 429, note the

following requirements, which are specific to F_Port trunking on an Access Gateway:

• The Access Gateway module must have the Trunking license enabled.