Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

14 Fabric OS Message Reference
53-1002448-01
Commands for displaying and configuring the system message logs
1
TABLE 3 Commands for viewing or configuring the system parameters and message logs
Command Description
auditCfg Configures the audit message log.
auditDump Displays or clears the audit log.
errClear Clears all error log messages for all switch instances on this control processor (CP).
errDelimiterSet Sets the error log start and end delimiter for messages pushed to the console.
errDump Displays the entire error log, without page breaks. Use the -r option to show the
messages in reverse order, from newest to oldest.
errFilterSet Sets an error severity filter for the system console.
errModuleShow Displays all the defined error log modules.
errShow Displays the entire error log, with page breaks. Use the -r option to show the messages
in reverse order, from newest to oldest.
pdShow Displays the contents of the panic dump and core dump files.
portErrShow Displays the port error summary.
portLogClear Clears the port log. If the port log is disabled, this command enables it.
portLogDisable Disables the port log facility.
portLogDump Displays the port log, without page breaks.
portLogDumpPort Displays the port log of the specified port, without page breaks.
portLogEnable Enables the port log facility.
portLogEventShow Displays which port log events are currently being reported.
portLoginShow Displays port logins.
portLogPdisc Sets or clears the debug pdisc_flag.
portLogReset Enables the port log facility.
portLogResize Resizes the port log to the specified number of entries.
portLogShow Displays the port log, with page breaks.
portLogShowPort Displays the port log of the specified port, with page breaks.
portLogTypeDisable Disables an event from reporting to the port log. Port log events are described by the
portLogEventShow command.
portLogTypeEnable Enables an event to report to the port log. Port log events are described by the
portLogEventShow command.
setVerbose Sets the verbose level of a particular module within the Fabric OS.
snmpConfig Manages the SNMP agent configuration.
supportFfdc Enables and disables FFDC.
supportFtp Sets, clears, or displays support FTP parameters or a time interval to check the FTP
server.
supportSave Collects RASLog, trace files, and supportShow (active CP only) information for the local
CP and then transfers the files to an FTP server. The operation can take several
minutes.
supportShow Executes a list of diagnostic and error display commands. This output is used by your
switch service provider to diagnose and correct problems with the switch. The output
from this command is very long.