Brocade Fabric Manager Administrator's Guide v6.1.0 (53-10000610-02, June 2008)

218 Fabric Manager Administrator’s Guide
53-10000610-02
Switch reboot
15
• Continue: Continues the reboot sequence when a timeout occurs.
• Abort: Terminates the reboot sequence when a timeout occurs.
The default selection is Prompt.
7. Type the amount of time that must elapse before the next reboot in the sequence begins in the
Delay After Fabric Stabilization field.
Fabric Manager considers a fabric stable when all WWNs appear in the fabricShow command
output.
8. Click OK.
Your reboot group is displayed automatically in the Reboot Groups tree.
The reboot groups listed in the Reboot Groups tree include bracketed text displayed next to the
name of the reboot group. The bracketed text represents the duration of the fabric stabilization
timeout, the timeout option (see step 6), and the duration of the delay after fabric stabilization time
that you configured.
Example
CoreSwitchRebootGroup [1m,P,2m]
In this example, 1m indicates a stabilization timeout of one minute, P identifies the timeout
option (Prompt), and 2m indicates that two minutes will elapse before the next reboot in the
sequence begins.
Creating single-switch reboot groups
1. Select Tasks > Reboot > Create Reboot Sequence.
The Create or Change Reboot Groups and Sequence dialog box displays (see Figure 142 on
page 217).
2. Select a fabric from the Select Fabric list.
3. Select a switch from the Unassigned Switches list. To create more than one single-switch
reboot group, select multiple switches. Each switch is made into its own single-switch reboot
group.
4. Click Create Single Switch Groups. The Create Single Switch Reboot Groups dialog box
displays, as shown in Figure 144.
FIGURE 144 Create single-switch reboot groups