Brocade Fabric Manager Administrator's Guide v6.1.0 (53-10000610-02, June 2008)

Fabric Manager Administrator’s Guide 141
53-10000610-02
Snapshots and change reports
9
Exporting switch configuration information
1. Select Tasks > Change Management > View CM reports.
The Change Management dialog box displays with the View Change Reports and Snapshots
tab selected (see Figure 89 on page 138).
2. Select the fabric containing the snapshots you want.
The Reports section for that switch displays a list of profiles and associated snapshots for that
fabric.
3. Select a snapshot in the Reports section.
4. Click Export Switch Config (in the Snapshots area) to extract switch configuration from the
snapshot and export it to a file.
The Save dialog box displays. You get an error message if the snapshot does not contain any
switch configuration information.
5. Type a name for the file and browse to the location where you want to save the file, then click
Save.
Printing snapshot and change reports
1. Select Tasks > Change Management > View CM reports.
The Change Management dialog box displays with the View Change Reports and Snapshots
tab selected (see Figure 89 on page 138).
2. Select the fabric containing the snapshot or change report you want.
The Reports section for that switch displays a list of profiles and associated snapshots for that
fabric.
3. Select a snapshot or change report, then click View (in the corresponding Snapshots or
Change Reports area).
The Change Report is displayed (see Figure 90 on page 139).
4. Click Print to print the snapshot or change report.
Changing the baseline snapshot
1. Select Tasks > Change Management > View CM reports.
The Change Management dialog box displays with the View Change Reports and Snapshots
tab selected (see Figure 89 on page 138).
2. Select the fabric containing the baseline snapshot you want.
The Reports section for that switch displays a list of profiles and associated snapshots for that
fabric.
3. Select a snapshot (other than the baseline) that you want to select as the new baseline
snapshot.
4. Click Change Baseline.