Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 465
53-1000600-02
Chapter
80
ZONE System Messages
ZONE-1002
Message <timestamp>, [ZONE-1002], <sequence-number>,, WARNING, <system-name>, WWN
zoneTypeCheck or zoneGroupCheck warning(<warning string>) at port(<port number>)
Probable Cause Indicates that a zone filter or zone group check failure occurred. The frame filter logic reported a
failure when creating or adding zone groups during port login (PLOGI) trap processing. This
messages usually indicates problems when adding content-addressable memory (CAM) entries
before the filter setup.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
ZONE-1003
Message <timestamp>, [ZONE-1003], <sequence-number>,, WARNING, <system-name>,
zone(<current zone>) contains (<domain id>, <port number>) which does not exist.
Probable Cause Indicates that the port zone member that is targeted for the local switch contains a non-existent
port. The effective zoning configuration (displayed in the error message) contains a port number
that is out of range.
Recommended
Action
Edit the zone database and change the port number to a viable value in the effective configuration.
Severity WARNING
ZONE-1004
Message <timestamp>, [ZONE-1004], <sequence-number>,, INFO, <system-name>, port <port
number>
enforcement changed to Session Based HARD Zoning.
Probable Cause Indicates that the zoning enforcement changed to session-based hard zoning. When a device is
zoned using both world-wide name (WWN) in one zone and <domain, portarea> in another, this will
cause that port to go session based hard zoning.