Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 419

53-1000600-02

SEC-1331

Message <timestamp>, [SEC-1331], <sequence-number>,, ERROR, <system-nam>, Attempt to

enable secure mode failed. Reason: <Reason>.

Probable Cause Indicates that the secModeEnable command failed on the fabric, because default IP Filter policies

are not active on the switch, or an active transaction exists on IP Filter policies.

Recommended

Action

Verify that the security event was planned. If the security event was planned, run the ipfilter

--activate default_ipv4 or the ipfilter --activate default_ipv6 command to activate default IP Filter

Policies. Use the ipfilter --save or the ipfilter --transabort commands to save or abort any active

transaction on IP Filter policies. Then retry the secModeEnable command.

Severity ERROR

SEC-1332

Message <timestamp>, [SEC-1332], <sequence-number>,, ERROR, <system-nam>, Fabric wide

policy is conflicting as <Policy Name> is present in the fabric wide policy and

5.3 or 5.2 switches present in the fabric.

Probable Cause Policy is conflicting.

Recommended

Action

Please remove either FCS from fabric wide policy or 5.3 and 5.2 switches from the fabric, or set the

fabric wide mode for FCS as Strict.

Severity ERROR