Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 399
53-1000600-02
SEC-1164
66
SEC-1164
Message <timestamp>, [SEC-1164], <sequence-number>,, ERROR, <system-name>, Lockdown
option cannot be applied on a non-FCS switch.
Probable Cause Indicates that the attempt to enable security is made on a switch that is not present in the fabric
configurations server (FCS) list.
Recommended
Action
Add the switch into the FCS policy list when using the lockdown option to enable security.
Severity ERROR
SEC-1165
Message <timestamp>, [SEC-1165], <sequence-number>,, ERROR, <system-name>, Low memory,
failed to enable security on all switches.
Probable Cause Indicates that the system is low on memory.
Recommended
Action
Wait a few minutes and try the command again.
Severity ERROR
SEC-1166
Message <timestamp>, [SEC-1166], <sequence-number>,, ERROR, <system-name>, Non FCS tries
to commit failover.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1167
Message <timestamp>, [SEC-1167], <sequence-number>,, ERROR, <system-name>, Another FCS
failover is in process. Command terminated.
Probable Cause Indicates that because another failover is already in progress, this failover attempt cannot proceed.