Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

258 Fabric OS Message Reference
53-1000600-02
FW-1434
30
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of
faulty CPs is greater than or equal to the policy set by the switchStatusPolicySet command. The CPs
are non-redundant.
If you power cycle a Brocade 24000 chassis in dual-domain configuration, and then reset the
micro-switch of the active CP before the heartbeat is up, this will cause both CPs to come up in a
non-redundant state.
Recommended
Action
Run the firmwareShow command to verify that both CPs have compatible firmware levels. Run the
firmwareDownload command to install the same level of firmware to both CPs. Replace any faulty
CPs.
If you reset the micro-switch (the latch on the CP blade) on the active CP before the heartbeat was
up on a power cycle, and the CPs came up non-redundant, then you should reboot the CPs again to
clear the problem.
Severity WARNING
FW-1434
Message <timestamp>, [FW-1434], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor Blade:
<Number Bad> blade failures.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of
blade failures is greater than or equal to the policy set by the switchStatusPolicySet command.
Recommended
Action
Replace the faulty blade.
Severity WARNING
FW-1435
Message <timestamp>, [FW-1435], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor Flash: usage out of range.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the flash usage is
out of range. The policy was set using the switchStatusPolicySet command.
Recommended
Action
Run the supportSave command to clear out the kernel flash. Refer to the Fabric OS Command
Reference for more information about this command.
Severity WARNING
FW-1436
Message <timestamp>, [FW-1436], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor Marginal ports: <Num of marginal ports and the port
numbers> marginal ports. (Port(s) <Unknown>)