Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

266 Fabric OS Message Reference
53-1002448-01
FCR-1055
37
Recommended
Action
Check the error message log on the other switch using the errShow command for additional
messages.
Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or SFP
if necessary.
Run the portLogDumpPort command on both the receiving and transmitting port.
Run the fabStateShow command on the transmitting switch.
If the message persists, collect switch information using the supportShow command, and contact
your switch service provider.
Severity WARNING
FCR-1055
Message <timestamp>, [FCR-1055], <sequence-number>,, INFO, <system-name>, Switch with
domain ID <domain ID> does not support backbone to edge imports.
Probable Cause Indicates that a switch that does not support backbone-to-edge routing was detected in the
backbone. Edge-to-edge routing will work, but backbone-to-edge routing might fail.
Recommended
Action
No action is required if backbone to edge routing is not required. Otherwise replace the switch with
one that supports backbone to edge routing.
Severity INFO
FCR-1056
Message <timestamp>, [FCR-1056], <sequence-number>,, INFO, <system-name>, Switch <switch
WWN> with front domain ID <domain ID> does not support backbone to edge imports.
Probable Cause Indicates that a switch that does not support backbone-to-edge routing is running in the MetaSAN.
Recommended
Action
No action is required if backbone-to-edge routing is not needed. Otherwise replace the switch with
one that supports backbone to edge routing.
Severity INFO
FCR-1057
Message <timestamp>, [FCR-1057], <sequence-number>,, ERROR, <system-name>, EX_Port(<port
number>) incompatible long distance parameters on link.
Probable Cause Indicates that the port, which is configured in long distance mode, has incompatible long distance
parameters.
Recommended
Action
Check the port configuration on both sides of the link using the portCfgShow command.