Brocade Fabric OS Message Reference - Supporting Fabric OS v7.0.1 (53-1002448-01, March 2012)

258 Fabric OS Message Reference
53-1002448-01
FCR-1020
37
FCR-1020
Message <timestamp>, [FCR-1020], <sequence-number>,, WARNING, <system-name>, Local LSAN
zone entries for FC router exhausted; max limit: <LSAN zone limit>.
Probable Cause Indicates that the number of logical storage area network (LSAN) zones created within a MetaSAN
exceeds the local LSAN zone database limitations.
Recommended
Action
Remove excess LSAN zones so that the number of LSAN zones created is within the range of local
database limitations.
To do that, perform the following steps:
1. Run the portDisable command to disable all the EX_Ports that got this error message.
2. Run the portDisable command to disable all the other EX_Ports on that FCR connected to the
same edge fabrics the EX_ports disabled in step 1 are connected to.
3. Use Zoning commands on the edge fabrics, to reduce the LSAN zone entries on the edge
fabrics.
4. Run portEnable on each EX_Port, one at a time, and verify that this error is not reported again.
Severity WARNING
FCR-1021
Message <timestamp>, [FCR-1021], <sequence-number>,, WARNING, <system-name>, Local LSAN
device entries exhausted.
Probable Cause Indicates that the number of devices created through logical storage area network (LSAN) zones
within the MetaSAN exceeds the local LSAN zone database limitations.
Recommended
Action
Remove excess device entries within LSAN zones so that the number of devices is within the range
of the local zone database limitations.
Severity WARNING
FCR-1022
Message <timestamp>, [FCR-1022], <sequence-number>,, ERROR, <system-name>, Local proxy
device slot entries exhausted.
Probable Cause Indicates that the resources used to persistently store the proxy device slot to the remote world
wide name (WWN) have been consumed.
Recommended
Action
Remove the proxy device slots by using the fcrProxyConfig command or limit proxy devices by
removing logical storage area network (LSAN) zone entries.
Severity ERROR