Brocade Fabric OS Administrator's Guide - Supporting Fabric OS v7.0.1 (53-1002446-01, March 2012)

Fabric OS Administrator’s Guide 319
53-1002446-01
Encryption and compression example
14
2. Peer secret: The secret of the peer that authenticates to peer.
3. Local secret: The local secret that authenticates peer.
Press enter to start setting up secrets >1
Enter peer WWN, Domain, or switch name (Leave blank when done):
10:00:00:05:1e:e5:cb:00
Enter peer secret:
Re-enter peer secret:
Enter local secret:
Re-enter local secret:
Enter peer WWN, Domain, or switch name (Leave blank when done):
Are you done? (yes, y, no, n): [no] y
Saving data to key store... Done.
myswitch:root> secauthsecret --show
WWN DId Name
-----------------------------------------------
10:00:00:05:1e:e5:cb:00 150 dcx_150
myswitch:root>
Next, you enable encryption on port 0. Note that the first attempt fails because the port is currently
enabled. This example uses the portCfgShow command to check the result. Notice that the output
shows encryption to be enabled on the port.
myswitch:root> portcfgencrypt --enable 0
Please disable port to configure Encryption/Compression.
myswitch:root> portdisable 0
myswitch:root> portcfgencrypt --enable 0
Turning ON Encryption on port(246) will cause the port to be disabled during
next LOGIN
myswitch:root> portenable 0
myswitch:root> portcfgshow 0
Area Number: 0
Octet Speed Combo: 3(16G,10G)
Speed Level: AUTO(SW)
AL_PA Offset 13: OFF
Trunk Port ON
Long Distance OFF
VC Link Init OFF
Locked L_Port OFF
Locked G_Port OFF
Disabled E_Port OFF
Locked E_Port OFF
ISL R_RDY Mode OFF
RSCN Suppressed OFF
Persistent Disable OFF
LOS TOV enable OFF
NPIV capability ON
QOS E_Port AE
Port Auto Disable: OFF
Rate Limit OFF
EX Port OFF
Mirror Port OFF
Credit Recovery ON
F_Port Buffers OFF
Fault Delay: 0(R_A_TOV)
NPIV PP Limit: 126
CSCTL mode: OFF