HP StorageWorks DAT SAS Tape Drives User Guide (DW092-90918, June 2010)
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
3. Connect the SAS cable to the tape drive. Attach the supplied power cord to the tape drive and
the mains power outlet.
3. Power on/off button1. SAS connector
2. Power cord
Figure 21 Connecting the cables to the DAT 320 tape drive
.
3. Power on/off switch1. SAS connector
2. Power cord
Figure 22 Connecting the cables to the DAT 160 tape drive
.
DAT SAS Tape Drives 39