HP 3PAR Command Line Interface Reference (OS 3.1.2 MU2) (QL226-97016, June 2013)

checkrclink
DESCRIPTION
The checkrclink command performs a connectivity, latency, and throughput test between two
connected HP 3PAR storage systems.
SYNTAX
• checkrclink startclient <N:S:P> <dest_addr> <time> [<port>]
• checkrclink stopclient <N:S:P>
• checkrclink startserver <N:S:P> [<dest_addr>] [<port>]
• checkrclink stopserver <N:S:P>
• checkrclink portconn <N:S:P>
AUTHORITY
• Super, Service
• Any role granted the rclink_check right.
NOTE: You need access to all domains in order to run this command.
SUBCOMMANDS
startclient
Starts the link test.
stopclient
Stops the link test.
startserver
Starts the system.
stopserver
Stops the system.
portconn
Uses the Cisco Discovery Protocol Reporter to show display information about devices that are
connected to network ports. Requires CDP to be enabled on the router.
The checkrclink test must be performed in two stages. For more information, see NOTES.
OPTIONS
None.
SPECIFIERS
<N:S:P>
Specifies the interface from which to check the link, expressed as node:slot:port.
<dest_addr>
Specifies the address of the target system (for example, the IP address).
<time>
Specifies the test duration in seconds.
[<port>]
checkrclink 67