HP 3PAR Command Line Interface Reference (OS 3.1.2 MU2) (QL226-97016, June 2013)

showport
DESCRIPTION
The showport command displays information about ports in the system.
SYNTAX
The syntax of the showport command can be one of the following:
• showport [options] [-failed] [-sortcol
<col>[,<dir>]][<node:slot:port> |<pattern>...]
AUTHORITY
Any role in the system.
OPTIONS
-i
Show hardware and inventory formation.
-c
Displays all devices connected to the port. Such devices include cages (for initiator ports), hosts
(for target ports) and ports from other storage systems (for RCFC and peer ports).
-par
Displays a parameter listing such as the configured data rate of a port and the maximum data rate
that the card supports. Also shown is the type of attachment (Direct Connect or Fabric Attached)
and whether the unique_nwwn and VCN capabilities are enabled.
-rc
Displays information that is specific to the Remote Copy ports.
-rcfc
Displays information that is specific to the Fibre Channel Remote Copy ports.
-peer
Displays information that is specific to the Fibre Channel ports for Data Migration.
-rcip
Displays information specific to the Ethernet Remote Copy ports.
-iscsi
Displays information about iSCSI ports.
-iscsiname
Displays iSCSI names associated with iSCSI ports.
-fcoe
Displays information that is specific to Fibre Channel over Ethernet (FCoE) ports.
-sfp
Displays information about hot pluggable SFPs attached to ports.
-ddm
Displays information about the SFPs DDM. This option must be used with the -sfp option.
-d
Displays detailed information about the SFPs attached to ports. This option is used with the –sfp
option.
440 Show Commands