3PAR InForm® OS 2.3.1 Messages and Operator's Guide (320-200181 Rev B, February 2010)

3.4
Understanding Component Numbering
Messages and Operator’s Guide InForm OS Version 2.3.1
Figure 3-3. Placement of the Service Processor
When a cabinet does not include a service processor, a filler panel covers the area of the
cabinet that the service processor normally occupies.
3.3 Understanding Component Numbering
Because of the large number of potential storage server configurations, 3PAR has standardized
component placement and internal cabling to simplify installation and maintenance. For this
reason, system components are placed in the cabinet according to the principles outlined in
this section and numbered according to their order and location in the cabinet.
NOTE: For T800 Storage Servers, the service processor is located above the storage
server backplane, below the lowest drive chassis but above the upper battery tray.
Figure 3-5 illustrates service processor placement for an T800 storage server.
0004_L_R3
Service Processor
Battery Tray
PDUs
(Visible Only
from the Back)
NOTE: For information about standardized cabling, see the 3PAR InServ® T-Class
Storage Server Installation and Deinstallation Guide.