HP 3PAR Command Line Interface Reference (OS 3.1.2 MU2) (QL226-97016, June 2013)

Specifies the port for which information about devices on that port are displayed.
node
Specifies the node.
slot
Specifies the PCI bus slot in the specified node.
port
Specifies the Fibre Channel port number of the PCI card in the specified PCI bus slot.
RESTRICTIONS
The loop subcommand is functional only in a private loop topology.
EXAMPLES
The following example displays information about all devices attached to Fibre Channel port
1:0:2:
cli% showportdev all 1:0:2
PtId LpID Hadr Node_WWN Port_WWN ftrs svpm bbct flen
0xd3 0x0c 0x00 2FF70002AC000013 21020002AC000013 0x8800 0x0022 n/a 0x0800
0xef 0x00 0xef 2000000087002078 2200000087002078 0x8800 0x0012 n/a 0x0800
0xe8 0x01 0xe8 2000000087002515 2200000087002515 0x8800 0x0012 n/a 0x0800
0xe4 0x02 0xe4 20000000870024CB 22000000870024CB 0x8800 0x0012 n/a 0x0800
0xe2 0x03 0xe2 20000000870028AE 22000000870028AE 0x8800 0x0012 n/a 0x0800
0xe1 0x04 0xe1 2000000087002224 2200000087002224 0x8800 0x0012 n/a 0x0800
0xe0 0x05 0xe0 2000000087003019 2200000087003019 0x8800 0x0012 n/a 0x0800
0xdc 0x06 0xdc 5000087000190E9F 5000087000190EA1 0x8800 0x0012 n/a 0x0800
0xda 0x07 0xda 2000000087002397 2200000087002397 0x8800 0x0012 n/a 0x0800
The columns in the previous example are identified as follows:
• PtId. The ID of the port.
• LpID. The ID of the loop.
• Hadr. The hard address.
• Node_WWN. The WWN of the node.
• Port_WWN. The WWN of the port.
• ftrs. Common features that are located in PLOGI_ACC common word 1, bits 31-16.
• svpm. The service parameters that are located in PRLI word 3, bits 15-0.
• bbct. The buffer to buffer credit that is located in PLOGI common word 0, bits 15-0.
• flen. The maximum received frame length that is located in PLOGI_ACC class-3 word 1, bits
15-0.
The following example displays the SAS topology for port 1:0:2:
cli% showportdev sas 1:0:2
The following example displays the SAS topology with PEL data for port 1:0:2:
cli% showportdev sas -pel 1:0:2
showportdev 451