HP 3PAR Command Line Interface Reference (OS 3.1.2 MU2) (QL226-97016, June 2013)

locatesys
DESCRIPTION
The locatesys command helps locate a storage system by blinking the node status LEDs on all
nodes of a storage system alternating between amber and green. By default, the LEDs in all
connected cages are also set as amber or oscillating (depending on the cage).
SYNTAX
locatesys [options <arg>]
AUTHORITY
• Super, Service
• Any role granted the sys_locate right.
NOTE: You need access to all domains in order to run this command.
OPTIONS
–t <seconds>
Specifies the number of seconds to blink the LEDs. The default is 60 seconds; the maximum is 255
seconds.
-nodes <node_list>
Specifies a comma-separated list of nodes on which to blink LEDs. The default is all nodes.
-nocage
Specifies that LEDs on the drive cages should not blink. The default is to blink LEDs for all cages
in the system.
SPECIFIERS
None.
RESTRICTIONS
Access to all domains is required to run this command.
EXAMPLES
In the following example, an HP 3PAR Storage System is identified by blinking the LEDs on all
drive cages in the system for 90 seconds.
cli% locatesys -t 90
NOTES
None.
locatesys 209