HP 3PAR Command Line Interface Reference (OS 3.1.2 MU2) (QL226-97016, June 2013)

createaocfg
DESCRIPTION
The createaocfg command creates an Adaptive Optimization (AO) configuration.
AUTHORITY
Super, Edit
SYNTAX
createaocfg [options <arg>] <aocfg_name>
OPTIONS
-t0cpg <cpgname>
Specifies the Tier 0 CPG for this AO config.
-t1cpg <cpgname>
Specifies the Tier 1 CPG for this AO config.
-t2cpg <cpgname>
Specifies the Tier 2 CPG for this AO config.
-mode <mode>
Specifies the optimization bias for the AO configuration, which can be one of the following:
• Performance — Move more regions towards higher performance.
• Balanced — Balanced between higher performance and lower cost.
• Cost — Move more regions towards lower cost tier.
The default optimization bias mode is Balanced.
SPECIFIERS
<aocfg_name>
Specifies an AO configuration name up to 31 characters in length.
NOTES
• Two or more Tier CPGs must be defined.
• If domains are used, all CPGs must be in the same domain or not in any.
• A CPG can only belong to one AO configuration.
• Active use of Adaptive Optimization requires an Adaptive Optimization license. Contact your
HP representative for more information.
EXAMPLES
The following example creates a new AO configuration called aocfg1. The optimization bias
(mode) is set to Cost. Tier 0 will use CPG R1SSDcpg, Tier 1 will use CPG R5FCcpg and Tier 2
will use CPG R6NLcpg.
cli% createaocfg -t0cpg R1SSDcpg -t1cpg R5FCcpg -t2cpg R6NLcpg -mode Cost aocfg1
createaocfg 105