HP 2500C/C+/CM Professional Series Color Printer - (English) User's Guide
Table Of Contents
- Contents
- Printer Basics
- Step 1 - Unpack the Printer
- Step 2 - Remove All Tapes from the Printer
- Step 3 - Connect Cables
- Step 4 - Set LCD Language Preference
- Step 5 - Install Ink Cartridges
- Step 6 - Install Printheads
- Step 7 - Load Paper in Tray 2
- Step 8 - Load Paper in Tray 3
- Step 9 - Align Printheads
- Step 10 - Install the Printer Software
- Basic Printing Tasks
- Maintaining the Printer
- Installing the PostScript Module
- Installing Additional Memory
- LCD Messages
- Troubleshooting
- Understanding the Diagnostic Test
- Customer Support
- HP Supplies and Accessories
- Printer Specifications
- Minimum Printing Margins
- Hewlett-Packard Limited Warranty Statement
- Declaration of Conformity
- Regulatory Notices
8
7
5
6
4
4. Loosen the four screws on the metal panel to remove it.
5. Insert the SIMM into SLOT 3 or 4 at a 45° angle.
6. Rotate the top of the SIMM until it is upright and clicks into position.
7. Lift the plastic flap, place the metal panel on the Rear Access Door
and fasten the screws.
8. Reconnect all cables to the back of the printer and power ON the
printer.
9. Press [MENU] until INFORMATION MENU appears. Press [ITEM] until
CHECK TOTAL RAM SIZE appears and press [SELECT]. The LCD
display should show the total amount of memory installed.
26