- Hewlett-Packard Printer User Manual

Alert message Description Recommended action
Manual feed The product is set for manual feed mode. Load the correct paper into the tray, and then
press the Go button to clear the message.
Non-HP black cartridge A new, non-HP supply has been installed.
This message appears until an HP supply is
installed or you press the Go button.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
To continue printing, press the Go button.
Not Connected The product software cannot communicate
with the product.
1. Make sure the product is turned on.
2. Make sure the USB cable is connected
securely to the product and the
computer.
Order black cartridge The identified print cartridge is nearing the
end of its useful life.
Order a new print cartridge. You can continue
printing with the current print cartridge until
redistributing the toner no longer yields
acceptable print quality.
Page too complex The product cannot process the page. Press the Go button to continue printing the
job, but output might be affected.
Printer mispick The print engine has failed to pick up a piece
of paper.
Reload the paper in the input tray and press
the Go button to continue the job.
If the message persists, contact HP support.
See
Customer support on page 117.
Printing The product is printing a document. Wait for printing to finish.
ENWW Status-alert messages 85