HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Configuring and Calibrating a PTM
73HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
Configuring a multi-unit library system using the control panel
To configure libraries in a multi-unit system using the control panel:
1. At the control panel, place each library in the off-line position.
2. Select the Multi-Unit (MUSL) tab.
3. Touch the Configure Multi-Unit button.
Note: When configuring PTMs in multiple libraries, each PTM must be configured
separately.
4. Enter Single, Master, or Slave in the Library Unit field. The library
connected to the host is the master library. HP recommends that the master be
the first library from the left of the multi-unit system (library 0). The
remaining libraries are slaves.
Caution: When configuring multiple libraries in MUSL mode, there can be
only one master library.
5. Enter a number (0-4) in the Library Unit # field (see Figure 36).
Figure 36: Library numbering (front view from control panel)
0 Library 0
1 Library 1
2 Library 2
3 Library 3
4 Library 4
5 Left-hand side
6 Right-hand side
0
65
4321
SHR-1776