HP StorageWorks Interface Manager and Command View TL Installation Guide (March 2005)
Table Of Contents
- Title
- Contents
- About this Guide
- 1: Introduction
- 2: Hardware Installation
- Preparing the Installation
- Installing the Expansion Cage in the ESL Series Library
- Installing the Fibre Channel Interface Controllers into the Expansion Cage
- Installing the Interface Manager Card into the Expansion Cage
- Connecting the Cables
- Connecting the Interface Manager Card to the Fibre Channel Interface Controllers
- Connecting the SCSI Bus Cables
- Connecting the Fibre Channel Cables
- Connecting the Interface Manager Card to the LAN
- Connecting the PC or Laptop
- Completing the Hardware Installation
- 3: Configuration and Software Installation
- 4: Troubleshooting
- A: Serial and Ethernet Pin Assignments
- B: Regulatory Compliance Notice
- Federal Communications Commissions Notice
- Harmonics Conformance (Japan)
- German Noise Declaration
- C: Electrostatic Discharge
- D: Specifications
- Index
79Interface Manager and Command View TL Installation Guide
D
Specifications
This section lists the environmental requirements of the Interface Manager card.
■ Operating Environmental Requirements
— Temperature: 0 to 50 ºC
— Relative Humidity: 5% to 80% (non-condensing)
■ Shipping and Storing Environmental Requirements
— Temperature: -40 to +55 ºC
— Relative Humidity: 0% to 92% (non-condensing)
■ Power Requirements
— VDC: 3.3V and 5V
—2.0A max
— 15W maximum power dissipation
■ Board Dimensions
— Size: 15.72 cm × 16.18 cm (6.19 in × 6.37 in)
— Height: 1.524 cm (0.60 in) max front surface
1.524 mm (0.06 in) max rear surface
— Thickness: 1.575 mm (0.062 in) max