- Hewlett-Packard Printer User Manual

HP PCL Commands
56 HP DeskJet 600, 700, 800, 900 & HP 2000 Series PCL Developer’s Guide
10.10.3 Move CAP Vertical (HP PCL Units)
If no such position exists, the printer moves to the logical page limit.
A signed value field indicates relative movement: plus (+) or minus (-) signs move CAP down-
ward and upward relative to CAP, respectively. The absence of a sign indicates absolute
movement: CAP moves an absolute distance from the top margin.
The current size, in units-per-inch, of a HP PCL Unit is specified by the Units of Measure
(Esc & u # D) command. Otherwise, the unit-per-inch for HP PCL movement defaults to 1/300
inch.
Except for the following, the effect of this command is limited to the logical page:
44 Positive relative positioning allows movement to the next logical page.
44 Negative relative positioning allows movement above the top of form, up to the limit of the
logical page or the top of the physical page.
After power on or reset, CAP moves to the top of form, if not already there.
HP DeskJet 600/800/900 & HP 2000 Series printers use 1/300”.
TABLE 35. Move CAP Vertical (HP PCL Units) - Esc * p # Y
#
Value
DJ600 DJ610C DJ660C DJ670C DJ680C DJ690C DJ695C DJ810C DJ830C DJ850C DJ870C DJ880C DJ890C DJ895C DJ970C HP2000C
EFFECT
n
44 44 44 44 44 44 44 44 44 44 44 44 44 44 44 44
Moves CAP specified number
of HP PCL units along the Y
axis
Default
n/a
Range
-32767 to +32767 - Command is ignored for out of range values