User Guide

164 Chapter 5 Service Calibrations
Service Calibrations
Perform the Line Sensor Calibration as follows:
1. In the Service Calibrations submenu, scroll to “Line Sensor Calibration” and press Enter.
2. When the following message appears on the front panel, you must select whether you would like to
continue with the calibration by pressing the Enter key. Press Back or Cancel to exit the
calibration.
3. If media is not loaded, the following message appears on the front panel. Load media in to the
Printer and start again from step 1.
Before continuing, the Printer will check the following:
• The Media Lever is in the lowered position.
• The correct paper type is loaded (check list on previous page).
• The correct paper size (minimum paper size 24 inches).
NOTE: Make sure you load one of the following media into the Printer before performing this
calibration:
•
HP Bond Paper.
• HP Glossy Media.
• HP Coated Paper.
• HP Productivity Photo Gloss.
• HP Heavyweight Coated Paper.
• HP Super Heavyweight Coated Paper.
• HP Bright White Inkjet Paper.