- Hewlett-Packard DesignJet Plotters User's Guide

This is the yellow on page 1–12 (seq: 26)

This is the magenta on page 1–12 (seq: 26)

1–12

Company confidential. Pelican User’s Guide, Ed 1, Final. Freeze Status: frozen

This is the cyan on page 1–12 (seq: 26)

This is the black on page 1–12 (seq: 26)

For each cartridge in the set:

1 Take the cartridge out of its box.

2 Remove the colored protective tape and tab

from the cartridge’s nozzles.

1754

Yellow

Cyan

Magenta

Black

r004

330

350C

For the 350C, match the color of the cartridge’s label with

the color of the dot above the stall.

3 Make sure that the plotter is still switched ON. (Never install cartridges

with the plotter switched off.)

4 Insert the cartridge in the stall. Press down lightly and push the cartridge

away from you until it snaps into place. If it is installed correctly, the

Ready light flashes for a few seconds. Otherwise, re-seat it.

0019

Localization Note JKCT: Similar to Parrot UG p1–13. FIGSP: Similar to Loquillo UG,

p1–21.

Setting up your plotter

Task 5: Load the print cartridges