Owner's manual

WARNING!
Before shutting down always ensure that there are no backup or restore jobs in progress and that no
future jobs are scheduled to start whilst the system is shut down. If hosts do not automatically reconnect
to the HP D2D Backup System when it restarts, you must reconnect manually from the iSCSI Initiator on
each host, see “Targets tab” on page 49.
Administration (Admin)
This page allows you to ma nage the Administrator’s password and amend the date and time settings.
When you first log on the Administrator user has a password of Admin. For security reasons, you
may wish to change this.
• Click Edit to make the fields editable.
• Make the required changes and click Update to apply the changes (or Cancel to discard them).
Resetting the password
If you forget your password, you can reset the HP D2D Backup System as follows:
NOTE:
Resetting the password will reset the networking settings to the factory defaults and reset the Administrator
password to Admin.Nouserdatawillbelost.
1. Make sure nobody is using the HP D2D Backup System before you attempt the reset.
2. Press the Power button on the front of the HP D2D Backup System three times in quick succession.
Approximately 5 seconds later the HP D2D Backup System will reboot.
3. Use the device discovery too l on the HP StorageWorks CD-ROM to re-configu re the network settings
of the HP D2D Backup System.
80
The Web Management Interface