Compaq TL881 MiniLibrary System Users Guide (May 1999)

Index 3
P
Pass-Through Mechanism Motor
Cable 3-26
Physical Configuration 1-6
Planning Your Installation 3-2
Platform Problems 6-1
Positioning the Modules 3-2
Power Cord 3-26
power supply 2-40
Power Supply 1-8
Power Switch 2-1
Power-On Self Test Screen 2-10
Preparing to Assemble the Pass-
Through Mechanism 3-7
R
Rack Slide Separation 3-16
Rackmounting in a Standard 19”
EIA/RETMA Cabinet 3-18
Rackmounting in a StorageWorks
(SW500, SW600, or SW800)
Metric Cabinet 3-19
Removing a Magazine 2-28
Removing Cartridges 2-27
Removing the Cleaning
Cartridge 5-4
Reserved Slots 3-37
Running the Cleaning
Cartridge 5-3
S
SCSI Interfaces 3-27
SCSI, daisy-chained 2-37
Security Menu 2-20
Selecting Control Panel Display
Modes 2-14
Set Auto Clean Mode 3-40, 4-14
Set Baud Rate 3-39, 4-14
Set Data Format 4-4
Set Date 3-39, 4-7
Set Default 3-40
Set Element Base 4-7
Set Identification 3-39
Set Library Mode 4-4
Set Mail Slot 3-40, 4-14
Set Negotiation 4-14
Set Negotiation Mode 3-40
Set Reserve Slot 4-14
Set Reserved Slots 3-40
Set SCSI 4-4
Set Sequential Configuration 4-4
Set Serial number 3-39
Set Serial Number 4-14
Set Special Configuration 3-40
Set Time 3-39, 4-14
Set Unload Mode 3-39, 4-14
Setting Base Module (slave)
Configuration 3-32
Setting up a Mail Slot 3-36
Show History Menu 2-20
Show Status Menu 2-18
Starting the System 2-10
System Expansion 1-7
T
Tape Cartridge Magazines 1-8
Tape Requirements 2-32
Terminator Installation 3-29
U
Using CE Diagnostics 6-25
Using the Demo Submenu 6-26
V
voltage ranges 2-40
W
Write Protection 2-34