DisplayMaker Legacy 72S and 72SR - User Manual

3-26 Loading Rigid Media
If you are creating a new media type, you are prompted for
the following settings:
◆ Feed Method — when you select Cut Sheet, the rigid
media options are enabled throughout the Media
Wizard.
◆ Pinch rollers — specify the pinch roller force setting as
shown on the label located on the pinch roller lever. Use
the lowest setting that holds the media in the rollers
without marking its surface.
4. Press one of the change keys to change any of the settings,
print mode, or media type, or press the ! key to continue.
◆ If you press one of the change keys, a screen appears to
allow you to change any of the settings. Then press the
! key to continue. See “Media Wizard” on page 3-32 for
information about these settings.
5. Enter the length of the media.
The control panel displays the prompt:
Load a sheet of media onto the printer
Fig. 3-8. Media settings