DisplayMaker Legacy 72S and 72SR - User Manual

1-8 Unpacking and Assembly
5. Lift the box straight up and off of the pallet.
6. Remove the protective shipping material from around the
printer, but leave the printhead carriage shrink wrapped.
7. Retain the Unpacking and Assembly Instructions (part number
0700024), which is shrink wrapped to the printer.
You can refer to the Unpacking and Assembly Instructions
(includes a parts list) with this manual during the unpack-
ing and assembly process.
8. Remove all of the parts and boxed kits, except for the printer
chassis, from the pallet.
9. Take an inventory of the parts, using the parts list in the
Unpacking and Assembly Instructions.
Report any missing or damaged parts to MacDermid
ColorSpan.
Stand Assembly 10. Locate the stand legs and the crossbar.
11. Lock the casters on both stand legs.
12. Using the twelve 10 mm hex-head screws provided, assemble
the stand (see Fig. 1-1).
Align the holes on the crossbar with the holes in the stand
legs, and attach the screws, but do not tighten them fully yet.
Fig. 1-1. Stand assembly