DisplayMaker Legacy 72S and 72SR - User Manual

4-4 AutoTune
AutoTune AutoTune runs jet maintenance automatically at intervals you
specify. You can use the Quality Check Mode feature to handle
AutoJet errors, with or without user intervention.
1. On the Front Page screen, press the  (Menu) key to enter
the menu system.
2. Press the  (Menu In) key display the Calibrate Printer
menu.
3. Press the ) key to highlight AutoTune.
4. Press the  (Menu In) key.
The control panel displays the AutoTune status (off or cur-
rent interval).
5. Press , or ) to set the AutoTune interval.
6. Press ! (Proceed).
The control panel displays a list of services for AutoTune to
run.
◆ Purge/Wipe
◆ Purge/Wipe & AutoJet
◆ AutoJet
Tip
Purge/Wipe takes the least amount of time, Purge/
Wipe & AutoJet takes the greatest amount of time.
Select Purge/Wipe & AutoSet only if Purge/Wipe
does not produce satisfactory results.
7. Select an AutoTune option to run.
8. Press the
" key, then the  (Menu Out) key.
The control panel displays a confirmation message:
Setting completed.
9. Press the  (Menu Out) key repeatedly until the Front Page
screen is displayed. Press the Online/Offline button to return
the printer to the Ready state.
Note
When AutoTune is enabled, the selected operations
will be executed as scheduled regardless of whether
you initiate them manually from the control panel.