HP DisplayMaker Legacy UV Printers - Site Preparation Guide

- 5 -
DisplayMaker Site Preparation Guide
Table 2: Specifications
Dimensions (Assembled) DisplayMaker 72
UVR, DisplayMaker 72UVX
Height: 52.5 inches (133.4 cm)
Depth without tables: 33.0 inches (83.8 cm)
Depth with tables: 87.7 inches (222.8 cm)
Width: 133.0 inches (337.8 cm)
DisplayMaker 98
UVX
Height: 52.5 inches (133.4 cm)
Depth without tables: 33.0 inches (83.8 cm)
Depth with tables: 87.7 inches (222.8 cm)
Width: 159.0 inches (404 cm)
Weight (Assembled) DisplayMaker 72
UVR, DisplayMaker 72UVX
Without tables: 375 pounds (170 kg)
With tables: 500 pounds (227 kg)
DisplayMaker 98
UVX
Without tables: 425 lbs. (193 kg)
With tables: 550 lbs. (250 kg)
Operating Conditions Temperature: 68–95° F (20–35° C)
Relative Humidity: 20–80%, non-condensing
Storage Conditions Temperature: -30–120° F (-34–49° C)
Relative Humidity: 10–80%, non-condensing
Agency Compliance Safety: CE
Emissions: FCC-A, CE
Immunity: CE
Electrical Power Power used: 200-240 VAC, single phase, 50/60 Hz, 16 Amps maximum
Required electrical circuit:
220 VAC, 20 Amps, with NEMA L6-20R locking wall receptacle (North America and Japan),
OR
220 VAC, 16 Amps, single phase, with IEC 60309 wall receptacle (Europe)
North America: If your building receives power from a standard three-phase supply, note
that the printer will use only two of the three phases. This means that your building’s three-
phase power transformer may have an unbalanced load. Check with your electrician to ver-
ify that your building has sufficient capacity for this unbalanced load.
NEMA L6-20R
locking wall receptacle
IEC 60309
wall receptacle
(North America/Japan)
(Europe)