DisplayMaker Legacy X-12+ - User Manual

1-10 Unpacking and Assembly
7. Remove the right-hand shipping support from the printer,
and bolt it to the pallet as shown, using the two red-headed
bolts provided. Do not remove the bolts from the rear sup-
ports.
Note that the “tower” of the support is now at the front of
the pallet.
8. Lift the left-hand shipping support from the pallet, reverse it,
and replace it into its guides on the pallet.
The “tower” of the support is now at the front of the pallet.
Fig. 1-5. Shipping supports reversed and bolted