DisplayMaker Legacy X-12+ - User Manual

5-8 Cleaning the Service Station
Cleaning the
Service Station
Maintenance interval: daily, and when switching between dye
and pigment inks.
Cleaning the service station helps to prevent dried ink from
clogging the ink jets. Keep a replacement set of wipers on hand
to replace damaged or worn wipers. A set of and twelve spare
wipers is included with the printer.
1. From the Front Page screen on the control panel, press the
Carriage key.
This moves the printhead carriage to the center of the platen.
2. Open the service station access door.
3. Reach inside the right endcap (behind the control panel) and
lift the service station out of the printer.
Hold the service station level to avoid spilling any ink that
may be present.
4. Hold the service station with the wipers under running water.
Rinse as much ink as possible from the wipers.
5. Blot any remaining water from the service station with a
clean, lint-free cloth.
To avoid contaminating the ink, be sure to dry all water
from the boots and boot holders.
6. Replace the service station into the printer.
7. Close the service station access door.
8. On the Front Page screen, press the Carriage key.
The printhead carriage returns to the service station.
Fig. 5-3. Service station parts
Boots
Wipers