DisplayMaker Legacy 72SI and 98SI - Print Server and Driver Setup Guide

1-24 Color Calibration
12. Click the button marked Take Calibration Readings.
◆ If you are using the onboard camera, go to step 13.
◆ If you are using the ColorMark Calibrator (X-Rite DTP22
spectrophotometer), go to step 14.
◆ If you are using the X-Rite DTP41 strip reader spectro-
photometer, go to step 19.
◆ If you are using the GretagMacbeth Eye-One Pro spec-
trophotometer, go to step 21.
◆ If you are using the GretagMacbeth Spectrolino
SpectroScan x/y table spectrophotometer, go to step
30.
Onboard Camera The printer reads each swatch with its onboard camera (spectro-
photometer).
13. When all of the strips have been read, go to step 34.
ColorMark Calibrator 14. Place the Calibrator in its stand, press and hold the base
until the reading is taken.
The server beeps when the reading is complete. Additionally,
the Calibrator vibrates as it reads and stops vibrating when
the reading is taken.
Take a white point reading before taking any color readings.
You can either take the white point reading or cancel and
restart the procedure.
15. Place a sheet of unprinted white media underneath the
Calibration Page before you take any readings.
16. Position the Calibrator’s eye on a clean white spot on the
calibration page.
17. Press and hold the Calibrator base until the white point
reading is taken.
After the white point reading is taken, the screen displays
the ColorMark Calibrator Window. For your information,
the Media Type, Print Mode, and Ink Type you selected
when you printed the Calibration Page appear near the top
of the dialog box.
a. Position the Calibrator's eye over the center of the first
colored square.